液压升降平台调试泵站的注意事项

液压升降平台http://www.jnyuexiang.com/在启动发动机时要注意如果没有异常即停机准备正式启动，一定要保证泵控制手柄在中位，液压升降平台启动后必须使其运转一段时间，方可进入工作状态。严格注意观察有无外泄液压油，仔细听有无异常噪声查看发动机有无重负，各个管路有无冲击，每个部位的温度升高是否正常。如果发现异常情况立即停机排查原因，非专业人员不要擅自拆卸否则会造成重大损失。
Hydraulic lifting platform when starting the engine to note that if there is no abnormal shutdown to prepare the official launch, we must ensure that the pump control lever in the neutral position, the hydraulic lifting platform must start it running for some time before they enter the working state. Strictly observe whether the leaked hydraulic oil, carefully listening to any abnormal engine noise to see whether the burden, whether the impact of the various lines,each part of the elevated temperature is normal. If abnormal situation immediately stop the investigation reasons, non-professionals do not disassemble this could cause significant damage.
      
液压升降平台http://www.jnyuexiang.com/液压泵站在搬运的时候注意轻拿轻放，不要使泵的控制手柄和溢流阀与硬物发生碰撞，严重撞击会使控制阀和伺服缸或补油泵以及溢流阀产生外泄漏油现象。液压升降平台在装上并正确连接完毕之后，向泵里注入清洁油也将上方卸油管卸下，见油液流出后拧紧接头，保证液压升降平台空运转时间使泵内回转体得到润滑，否则容易磨损或烧坏回转元件。
Hydraulic lifting platform pump standing handling when the attention gently, do not make the pump and pressure relief valve control handle with a hard object collision, serious impact would control valves and servo cylinder or produced outside the charge pump and pressure relief valve oil leakage phenomenon. After the hydraulic lifting platform on the installation is complete and correctly connected to the pump will inject clean oil above the unloading tube removed,see the oil outflow after screwing tight fitting, ensure that the hydraulic lift platform idling time for the body to get lubricated rotary pump, otherwise easy to wear or burn rotating components.